(03-17-2016, 12:33 PM)pir8man Wrote: Javitux. our assistance is only as good as the information you provide.Its actually conected to SATA 6G. This ssd is rate to get 520mbs on read almost. If I conect to SATA 2 will improve the speed over 392mbs?
What controller is your SATA plugged into?
What speed is your SSD capable of? (if its rated for 400mb/s and you are getting 392, i wont waste my time on that)
It sounds like you have your SSD connected to the Marvell controller. This is WRONG. SSD NEED to be PCIe or on INTEL controller with this board.
Best speed on this board with a single SSD drive will be to use: S18i MOD with SSD connected to INTEL SATA ports. Set INTEL SATA to AHCI mode and use driver 11.2.0.1006 DRIVER (NOT full RST Software) only.
As you have SSD and a SATA2 HDD, connect both to INTEL SATA ports. and DISABLE Marvell controller in BIOS.
And another question, thanks for your time
EDIT: Im idiot, sorry. I disabled SATA 6G controller from bios and enabled AHCI intel chipset. I move the SATA ssd cable to SATA 2 port and I will try to install only driver. I will tel us the results.