Supermicro X9DR3-LN4F+ intel qdnr e5 2670v2 es

[rathi]

Done everything (Instead of slot 6 which is for CPU2, I inserted it in slot 3 which is last PCIe for CPU1) and still no luck.
Also tried with R3.0 again but without success.
It is strange that if I looks via IPMI Sensor Readings, it gives clear indication to voltage 0.976 Volts along with its threshholds (min/max volts).

Isn't this means that the Board is able to recognize CPU and read its voltage parameters? At the same time temp sensors says CPU 1 "Not present" in the system (which means it cannot read temp of the CPU).
I observed that the CPU heat sync gets hot on touching after some time which indicate: I don't know what. But at the same time no Beeps, no Display and no Boot.

Tried all these versions now : 2.0, 3.0, 3.0a, 3.0b, 3.2 without success. I have version 1.1a as well.

Any other suggestions? anyone? for the processor detailed here : http://i.ebayimg.com/images/g/xt4AAOSwfY...s-l500.jpg

Thanks in Advance!