(12-30-2014, 10:21 PM)gto4ben Wrote:Yes, I have tried Failsafe Defaults as well as Optimized Defaults. I have also tried Post 58 BIOS.(12-30-2014, 09:49 PM)CCWTech Wrote: Just tried the Bios in Post 45 for my 1.6 rev. it get's to Verifying DMI Pool Data... and stops. Any Suggestions?
I have 2 4TB drives I'd like to run in a Raid 1.
Have you asserted the "Load Optimized Defaults" in the bios after you flashed the new bios? This is a necessary step to clear the old bios settings. You'll then have to set the appropriate settings for you setup. Be sure to check the HD boot order in the bios or it will try to boot from a USB stick or a drive without a OS. Be sure your power suppy is up to the task as well since adding the drives on a marginal PS will result if strange behavior.
I don't have any USB devices plugged in and have checked the boot order. It's got a 700 W PSU (this used to be a server). When I disconnect the drives, it boots fine.