05-13-2017, 06:26 PM
(This post was last modified: 05-13-2017, 06:31 PM by QWERASDFZXCV.
Edit Reason: Adding another question.
)
Hi everyone, this is my first post. I can really use you guys help as I am stuck at my first trial on modding the BIOS.
My goal is to unlock all menus and option in Bios setup
I download and used to HP Bios updater to save the Bios file. There are 2 files. Then I loaded the first one in AMIBCP, changed all tabs and options to USER. However, I found a post (forget the link) about AMIBCP corrupting Bios save.
My questions are:
1. Should I use a hex editor instead of AMIBCP? If so, how?
2. How can I flash the Bios after modding it?
I have attached the 2 bios files below. Any help will be very much appreciated.
BTW, there are two .sig files following the BIOS files. I think may be the Bios will check the bios with the sig file when flashing.
[attachment=12479]
Edit: changing question 1
My goal is to unlock all menus and option in Bios setup
I download and used to HP Bios updater to save the Bios file. There are 2 files. Then I loaded the first one in AMIBCP, changed all tabs and options to USER. However, I found a post (forget the link) about AMIBCP corrupting Bios save.
My questions are:
1. Should I use a hex editor instead of AMIBCP? If so, how?
2. How can I flash the Bios after modding it?
I have attached the 2 bios files below. Any help will be very much appreciated.
BTW, there are two .sig files following the BIOS files. I think may be the Bios will check the bios with the sig file when flashing.
[attachment=12479]
Edit: changing question 1