i have a m2n mobo i would like it to support the phenom x2 545
so i started out with downloading mmtool and i opened my bios i saw that i had these microcode in my bios :
so i opened a bios from a kind of similar board with newer microcode and imported these into the original bios from my board :
saved it and flashed.
it booted ok with the old 4450e but when i change the cpu to my 545 it wont boot just sits there fans blowing
i realized i have to update the AGESA code some how but this is way out of my league
edit:
i exported the b1 block from my bios and i found some cpu names but i have no clue on how to change the agesa i assume i have to find the header and the footer and work from there but i have no clue how they look
and if its even possible this way
can someone help me in the right direction ?
so i started out with downloading mmtool and i opened my bios i saw that i had these microcode in my bios :
so i opened a bios from a kind of similar board with newer microcode and imported these into the original bios from my board :
saved it and flashed.
it booted ok with the old 4450e but when i change the cpu to my 545 it wont boot just sits there fans blowing
i realized i have to update the AGESA code some how but this is way out of my league
edit:
i exported the b1 block from my bios and i found some cpu names but i have no clue on how to change the agesa i assume i have to find the header and the footer and work from there but i have no clue how they look
and if its even possible this way
can someone help me in the right direction ?