[REQUEST] Acer Aspire 5738(G,Z): CPU Upgrade & Microcode Update

[vesman]

vesman
Your laptop is base on GL40 withou support of FSB=1066 Mhz. So you can't use your P8600.
T8100, T8300, T9300 and T9500 are recommended.

Thank you very much DeathBringer, you are the man   So now I will look for 800mhz CPU. THANKS!

[n3770_]

Make DOS USB-stick (e.g, by Rufus)
Copy phlash16.exe and file with mod (JV50134m.WPH)
Boot into native DOS and run
phlash16 /x /s /c /mode=3 JV50134m.WPH

still works, thanks a lot.

[lucky42]

Hello, can you re-upload the bios that supports the t7500 processor for the Aspire 5738?? Thank you!!

[DeathBringer]

Tell sSpec of your T7500.

[lucky42]

I'm not very experienced in this matter, but I still took a chance and tried to update the BIOS using a flash drive created by the Rufus program with the addition of the files described in the post above and I succeeded, and now the laptop boots without errors.
I apologize for the extra hassle.

[lollo90]

hey  thanks!!! this mod save me after 8 hours of resercing on the web a bios mod to remove an error on boot (02f0) after a cpu  upgrade on a 5738z  from a t4200 to t7500 !!! THANKSSS!!All cpu s you suggest is 1066 FSB.

You think this laptop can run at 1066?

I'm sure it can.

Also i have allready this cpu ( T 7700)

Try to flash my BIOS mod.

[Rehmi]

vesman
Your laptop is base on GL40 withou support of FSB=1066 Mhz. So you can't use your P8600.
T8100, T8300, T9300 and T9500 are recommended.

Hi ! Kinda new here, absolutely flabbergasted that this thread is almost 15 years old and still somewhat active.

I recently upgraded from a T4500 to a T9300 (GL40 chipset, official BIOS v1.33) on my Acer Aspire 5738, but it doesn't seem to work out of the box. I can get to the BIOS and it shows that the CPU is correctly recognized, but i can't get my pc to boot to windows. It sort of "boot cycles" constantly. I tried booting into a bootable USB drive with the windows installation media in it, and it does show the windows logo for a split second but then it stops immediately and shows a black screen. Missing microcode maybe ?

Is there any way to help me ?

[DeathBringer]

Post a screenshot of Mainboard tab of CPU-Z.

[Rehmi]

Post a screenshot of Mainboard tab of CPU-Z.

There you go ! I put back the T4500 in to take that screenshot (seems to confirm that the problem comes from the upgrade). Quick sidenote, i was surprised to see that the chipset isn't the GL40 but the GM45.

[DeathBringer]

I think your T9300 is dead.